Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instructions
Presenter with Touch
Item No. 1826704
Intended Use
The product controls a computer by wireless
The model is ideal for controlling presentation or
multimedia programs.
Also other programs or the user interface of an
operating system can be controlled by means of an
integrated touchpad and two mouse buttons.
The small USB receiver can be inserted into the
presenter operating unit for transportation so it is
not lost.
The presenter is powered by batteries.
It is imperative that you follow the safety instructions
and all other information contained in this user
manual.
This product complies with the statutory national and
European requirements. All company names and
product names are trademarks of their respective
owners. All rights reserved.
Delivery Content
• Presenter
• USB receiver
• Operating instructions
USB receiver is inserted into the
presenter on delivery. Open the battery
compartment lid to remove.
Up-to-date Operating Instructions
Download the latest operating instructions at www.
conrad.com/downloads or scan the QR code shown.
Follow the instructions on the website.
Explanation of Symbols
The symbol with the exclamation
mark in the triangle is used to indicate
important
information
in
operating instructions. Always read this
information carefully.
The arrow symbol indicates special
information and advice on operation.
Safety Instructions
In case of damage caused by non-observance of
these operating instructions, the warranty gets
void! We are not liable for any consequential
damage!
We are not liable for property damage or injuries
caused by improper use or non-observance of
safety instructions! Such circumstances will void
the warranty!
• Due to safety and approval concerns the product
must not be modified and/or altered without
authorization.
Inserting batteries, changing batteries
• Open the battery compartment at the rear of the presenter and insert two type AAA/Micro batteries with the
correct polarity (please note: plus/+ and minus/-).
On initial start-up of the presenter remove the small USB receiver which is located in a
compartment under the battery compartment cover.
• Reclose the battery compartment.
• It is recommended changing the battery when the wireless range is greatly reduced if the computer no
longer reacts to the control commands of the presenter.
Removing/storing the USB receiver
The USB receiver is located in a compartment under the battery compartment cover. Open the battery
compartment cover and remove the USB receiver. Reclose the battery compartment.
When transporting or storing the presenter reinsert the USB receiver into the presenter so that the small
USB receiver is not lost.
• The product should only be operated in dry, closed
interior spaces. It should not be exposed to damp
or wet.
• This product is not a toy, keep it out of the reach
of children.
• Operation in areas with high level of dust,
flammable gases, vapors or solvents is not
authorized. There is a danger of fire and explosion!
• Do not leave packaging material unattended, as
children could use it as a toy creating hazardous
situations.
• Treat the product with care. Damage can be
caused by impacts, blows or dropping from a low
height.
Battery / rechargeable battery
information
• Keep (rechargeable) batteries out of the reach of
children.
• Do not leave batteries lying around. There is a
risk that children or pets swallow batteries. If a
battery has been swallowed, seek medical advice
immediately.
• Leaking or damaged (rechargeable) batteries can
cause burns when in contact with skin. You should
thus wear suitable gloves in such a case.
• Chemicals running out of batteries/rechargeable
batteries are very aggressive. Objects or surfaces
which can come into contact with it can sometimes
be extensively damaged. Therefore keep batteries/
rechargeable batteries in a suitable place.
• Do not short-circuit and disassemble batteries. Do
not throw into fire. There is a risk of explosion!
• Do not recharge common batteries that are not
rechargeable. There is a risk of explosion! Only
use batteries exclusively provided for this. Use a
suitable charger.
these
• Do not mix batteries or rechargeable batteries .
Either use batteries or rechargeable batteries.
• Do not mix any batteries or rechargeable batteries
in a different condition (e.g. full or half full batteries
or rechargeable batteries).
• Always replace the whole set of batteries/
rechargeable batteries.
• Please note the correct polarity (plus/+ and
Minus/-) when inserting the batteries/rechargeable
batteries.
• If you want to use rechargeable batteries please
ensure that the reduced output voltage (batteries
1.5 V, rechargeable batteries - 1.2 V) do not lead
to a reduction of the operating time and a reduction
in LED brightness.
• Therefore we recommend you only use high quality
alkaline batteries for operating the presenter to
ensure long and fault free operation.
Getting Started
• Start the operating system (e.g. at least Windows 2000/XP or later).
• Connect the USB receiver to the computer. The operating system recognizes the new hardware (USB
keyboard and USB mouse) and installs the necessary driver (included in the operating system).
• The product is ready for operation on concluding the driver installation.
Operation
• The presenter is activated on pressing any key. The presenter automatically switches itself off after
approximately 3 minutes of not being used to save power. The blue LED on the presenter goes out. Simply
press any key to reactivate.
If the receiver is out of range (of if the PC is shut down), the blue LED flashes on the presenter.
After a while the presenter switches itself off to save power. The LED goes out.
• The rippled surface at the upper end of the presenter serves as a touchpad, similar to a notebook. The left/
right mouse button is identified with an image.
• The other control keys correspond with those on a conventional multimedia keyboard (e.g. switch PC on/
off and displaying the menu functions of the operating system).
• The control pad conforms with the cursor keys of a conventional keyboard, the "OK" key is covered by the
function of the Enter Key.
Maintenance and cleaning
• Apart from the occasional battery change the product is maintenance free. There are no components
inside the product which need to be maintained by you.
• To clean the product, a dry, soft and clean cloth is sufficient. Touching the housing too hard (special
transparent cover and touchpad) can cause scuffs.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can cause
damage to the housing and malfunctioning.
Declaration of Conformity (DOC)
Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau hereby declares that this product
conforms to the 2014/53/EU directive.
Click on the following link to read the full text of the EU declaration of conformity: www.conrad.
com/downloads
Select a language by clicking on a flag symbol and enter the product order number in the search
box. You can then download the EU declaration of conformity in PDF format.
Disposal
a) General
At the end of its service life, dispose of the product in accordance with applicable regulatory
guidelines.
Remove any inserted (rechargeable) batteries and dispose of them separately from the product.
b) (Rechargeable) Batteries
You as the end user are required by law (Battery Ordinance) to return all used batteries/
rechargeable batteries. Disposing of them in the household waste is prohibited.
Contaminated batteries/rechargeable batteries are labeled with this symbol to indicate that
disposal in the domestic waste is forbidden. The designations for the heavy metals involved are:
Cd = Cadmium, Hg = Mercury, Pb = Lead.
Used (rechargeable) batteries can be returned to collection points in your municipality, our stores or wherever
(rechargeable) batteries are sold.
You thus fulfill your statutory obligations and contribute to the protection of the environment.
Technical Data
a) Presenter
Power supply ........................................ Battery: 2 x AAA 1.5 V/DC (not included)
Transmission frequency........................ 2.407 - 2.477 GHz
Transmission power.............................. < 5 dBm
Transmission distance .......................... approx. 10 m (open area)
Modulation type .................................... GFSK
Operating conditions ............................. -10 to +60 ºC, 20 – 80 % RH
Storage conditions ................................ -20 to +80 ºC, 20 – 80 % RH
Measurements (W x H x D) .................. 39.7 x 23 x 132.5 mm
Weight .................................................. 41.6 g
a) USB Receiver
Power supply ....................................... via USB
Connection ........................................... USB 2.0
Operating conditions ............................. -10 to +60 ºC, 20 – 80 % RH
Storage conditions ................................ -20 to +80 ºC, 20 – 80 % RH
Measurements (W x H x D) .................. 14.3 x 6.2 x 18.7 mm
Weight .................................................. 1.6 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights
including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represents the technical status at the time of printing.
Copyright 2019 by Conrad Electronic SE.
*1826704_v2_0419_02_dh_m_en
Werbung
