Deskshaper Pro BIS514 Handbuch Seite 9

STEP 6
Place (Q), (R) on (P), then use (L) to turn the
screws in the base (B) and the frame.
STEP 7
Carefully adjust the plastic bottom casing of
the frame (B) so that the four holes of the
bottom casing alignment are correct. Use
(0) as screws.
STEP 8
Place panel (C) at the top of (A).
STEP 9
Insert (D) into the plastic tube of (A), with
(G) pulled out, then push (D) to the desired
height and release (G) to secure the saddle.
STEP 10
Use (L) to remove the bolt and washer from
(H), place (H) in the adjusting xed plate,
and alignthe screw holes. Use (L) for
securing.
- 7 -
EN