Rompa 18280 Anleitung

PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT
DESCRIPTION
The Auto Ballpool Ball Washer will clean 7.5cm diameter balls. Do not use this product to clean balls
of any other size. The Auto Ballpool Ball Washer is capable of cleaning 20,000 7.5cm balls in an
hour.
CONTENTS
The Auto Ballpool Ball Washer includes:
• Ball washer with integrated vacuum unit
• 10 metre water drainage hose
• 5 metre transparent suction hose
• 1.5 metre transparent hose
• 300 detergent tablets
• 1 Brush
• 25 nets
OPERATION
1. Before using your Auto Ballpool Ball Washer remove the loose parts stored inside it (transparent
hose, drainage hose and ball netting system). Do NOT remove the water pump.
2. Before filling the unit with water, move your Auto Ballpool Ball Washer to desired location.
Please note: The Auto Ballpool Ball Washer should not be moved when full.
The unit is on castors to help you to move it to desired location. When choosing this location
consider:
2i. Make sure the Auto Ballpool Ball Washer is on a level surface.
2ii. Choose a location where the unit can be easily drained after use.
2iii. Make sure there is a socket nearby.
2iv. Choose a location where you can easily fill the unit with water.
2v. Make sure you have enough room to work in.
2vi. Consider the location of your ballpool and how easily you can empty the balls
from it. You may find it easiest to vacuum the balls into a net using the suction hose, and then
move the net to the Auto Ballpool Ball Washer.
3. Fill the unit with water (preferably warm, but not exceeding 35°C) up to the level indicated. Do
NOT fill beyond this mark.
4. Add the detergent tablets. The amount of tablets you use depends on the amount and dirtiness
of the balls being cleaned. Do not use more than ten tablets per wash.
5. Place the ball netting frames (50A/50B) in the holders (51A/51B), matching left and right
correctly.
AUTO BALLPOOL BALL WASHER 18280
Copyright ROMPA® Ltd
AUTO BALLPOOL BALL WASHER 18280, KH 10.09