Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Use buttons to set occupancy
Step 1.
Press and hold
Step 2.
Toggle through the
Step 3.
After 60 seconds
the blue button until the
occupancy level settings
the configuration mode
ESD controller says 'config
using both the yellow and
will disable and the unit
mode enabled'
blue buttons
will function as normal
'leaving config mode'
60 seconds
timeout
Testing the ESD
Once configuration is complete you should test the system by connecting a telephone
to the system and putting the elevator into normal use.
Enter the elevator to check the system sees
the correct number of people in the status
section.
If only able to test with one person, set
the occupancy level to zero and enter the
elevator to check that:
- the audio can be heard
- the audio interval is acceptable
- the doors are held open when the
occupancy level is exceeded
If the tests are succesful then the installation is complete.
If an error occurs please contact your local Avire Technical Support Team - their contact
details are available at
www.avire-global.com
5
Werbung
Inhaltsverzeichnis
