Rompa 14520-1 Montageanleitung

SOUTHPAW TUBE SWING, 14520-1, 16780
NOTE: Under no circumstances is the Tube Swing to be used without a Safety
Rotational Device (13738) and Safety Snap (13799).
CONTENTS
TUBE SWING HARNESS 14520 :
TUBE 14521 :
Please note: Inflator is not included. 14521 should be used in conjunction with
14520.
TUBE SWING SET 16780 :
NOTE: On receipt of goods please check for any damage which may have
occurred in transit.
NOTE: All hanging equipment requires a minimum ceiling height of 8 feet/2.5
metres and should be positioned a clear distance of 6 feet/1.8 metres from any adjacent walls and
other obstacles.
Maximum weight supported: 250lbs (approximately 125kg).
NOTE: To prevent damage to your equipment a Safety Rotational Device (13738) and Safety
Snap (13799) should be used. A professionally fitted Hanging Bracket (13672) is needed. A
Height Adjuster (13626) may be needed. See ROMPA Catalogue for details.
ASSEMBLY
INSTRUCTIONS
1. Inflate the tube to the
desired size.
2. Slip the valve cover
over the valve stem.
3. Wrap the harness
around the
taking care to cover
the valve
completely.
4. Pass the Velcro
through the metal loop
(Velcro replaced
lacing
September 2003).
This should be a snug
fit, but not a really
tight fit. The harness
will not slip once the
Tube Swing is in use.
tube,
stem
fitting
1 x Tube Swing Harness
1 x Valve Stem Cover
1 x Tube
1 x Tube Swing Harness
1 x Valve Stem Cover
1 x Tube
SOUTHPAW TUBE SWING, 14520-1, 16780, KH 2.14
Copyright ROMPA® Ltd