Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instructions
Speaker Pole
Item no. 30 10 89
Intended use
Use the speaker pole to attach satellite/subwoofer combinations with standard mounting flanges. The
speaker pole allows you to set the height of the attached speaker/subwoofer. The speaker pole is designed
for even load distribution up to 25 kg max.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use
can cause hazards such as injuries etc. Read the operating instructions carefully and keep them. Make this
product available to third parties only together with its operating instructions.
Delivery content
• Speaker pole
• Retainer pin
• Operating instructions
Safety instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
a) Persons / Product
• With heavy speakers/subwoofers, have an extra person give you assistance to avoid injuries
(such as back injuries).
• Always double secure the load. For this, use both the clamping screw and the safety bolt.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become dangerous
playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it
from any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage
the product.
• Also observe the safety and operating instructions of any other devices which are connected
to the product.
b) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the device.
• Maintenance, modifications and repairs are to be performed exclusively by an expert or at a
qualified shop.
• If you have questions which remain unanswered by these operating instructions, contact our
technical support service or other technical personnel.
Operating elements
Version 02/13
6
5
1 Upper rod
2 Bolt opening (two-sided)
3 Safety bolt
4 Allen screw
5 Lower rod
6 Clamping screw
Operation
The speaker pole with base can fall over, causing very serious injuries. You must
therefore keep the immediate area around the product clear at all times and ensure that
people do not stand in this area.
You must make sure that the speaker pole is uniformly loaded.
Do not move the speaker pole with base, when a speaker/subwoofer is mounted.
• Check the fit of the Allen screw (4). If required, fasten it using a suitable Allen key.
• Insert the tapered end of the lower rod (5) into a suitable base with standard opening (Ø36 mm). You must
ensure that the base is designed for the weight and that the speaker pole is placed firmly in the base.
• Place the base on a clean, level and stable surface that can withstand the weight of speaker pole and
speaker/subwoofer.
• Loosen the clamping screw (6) in counterclockwise direction and pull the speaker pole out to the required
height.
• Push the safety bolt (3) through the bolt opening (2) and lower the rod until the safety bolt stops it lowering
further. Tighten the clamping screw, by turning it clockwise.
• Mount a speaker/subwoofer on the end of the upper rod using a standard flange (inside Ø 36 mm). Mount
the speaker/subwoofer to the speaker pole. If required, consult the operating instructions of the speaker/
subwoofer or contact an expert, if you are not sure about anything.
• If necessary, loosen the clamping screw and set the direction the speaker is facing. Always tighten the
clamping screw again!
Cleaning
• Use a soft, anti-static and lint-free cloth for cleaning.
• Do not use any chemical or abrasive cleaning agents.
Disposal
At the end of its service life, dispose of the product according to the relevant statutory regulations.
Technical data
Height setting ....................... Hole 1: 135 cm
Load capacity ...................... max. 25 kg
Tube diameter...................... upper tube: Ø35.5 mm
Weight ................................. 550 g
These operating instructions are published by Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau/Germany
(www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. The operating instructions
reflect the current technical specifications at time of print.
We reserve the right to change the technical or physical specifications.
© Copyright 2013 by Conrad Electronic SE.
1
2
3
4
Hole 2: 120 cm
Hole 3: 105 cm
Hole 4: 90 cm
lower tube: Ø38.5 mm
tapered lower tube: Ø35.5 mm
V1_0213_02-JH
Werbung
