Power Supply - QEO F6 Bedienungsanleitung

EN
B

POWER SUPPLY

Connect the power plug with the charger and the socket.
Place the rechargeable battery only or the entire unit into the
charger. Take care that the battery is connected correctly to
the charger.
The red LED at the unit shows the start of the charging
process. After approx. 3 to 4 hours the red LED stops
flashing and the green LED begins to flash. Now the
charging process is completed and the battery / unit
can be taken off the charger.
The battery has not been fully charged from the factory. Before
first use the battery must be fully charged. If necessary repeat the
charging process several times.
In normal use do not recharge the battery if it has been fully charged or if the unit is not in low battery
alarm state.
MOUNT THE ANTENNA
Screw the antenna with its base into the corresponding adapter.
Take care that the antenna is well fixed.
INSERT / TAKE OFF THE BATTERY
To remove the battery push the battery lock upwards and pull the
battery out.
To install the battery match the two pins at the bottom of the
battery with the corresponding slots at the bottom of the unit
and press the top of the battery towards the unit until you hear
a "click".
12
Battery lock