E+E Elektronik CO2 Guard 10 Kurzanleitung Seite 2

QUICK GUIDE
CO Guard 10
2
The CO Guard 10 shows the carbon dioxide (CO
2
quality (IAQ) and can indicate the need for ventilation for instance by opening the windows. Air exchange based on the
actual CO concentration can significantly reduce energy costs.
2
Scope of Supply
CO Guard 10
2
4 pcs. AAA 1.5 V alkaline batteries
Significance of LEDs
The LEDs show the actual CO
LED flashes
1)
Red 2
Red 1
Yellow 2
Yellow 1
Green 2
Green 1
1) All LEDs flashing together: Weak batteries
Red 2 continuously on: Error
2) Note: The outdoor CO
2
Enclosure, Mounting
Putting into Operation
Insert the batteries observing the right polarity and close the enclosure (see above).
The CO Guard 10 shall be placed far from the windows and min. 1.50 m (5 ft) from people
2
Battery Replacement
All LEDs flashing together indicate weak batteries. For replacement use alkaline batteries type AAA 1.5 V or rechargeable
batteries of type AAA 1.2 V only. Open/close the device as described above.
Safety Information
When employing rechargeable batteries,
an appropriate battery charger (not in the scope of supply).
This device is not appropriate for safety, emergency stop or other critical applications where device malfunction or failure
could cause injury or damage to human health.
For disposal, the individual components of the device must be separated according to local recycling regulations. Especially
the batteries shall be disposed of
INFORMATION
E+E Elektronik Ges.m.b.H.
Langwiesen 7 • 4209 Engerwitzdorf • Austria
Tel: +43 7235 605-0 • Fax: +43 7235 605-8
info@epluse.com • www.epluse.com
LG Linz Fn 165761 t • VAT-No. ATU44043101
Place of Jurisdiction: 4020 Linz • DVR0962759
Wall mounting set
Tabletop adapter
Quick guide
range in a traffic light style which indicates an IAQ rating as shown in the table:
2
CO range [ppm]
2)
2
Higher than 3000
2000...3000
1400...2000
1000...1400
800...1000
Lower than 800
concentration is approx. 400 ppm
Opening the enclosure:
Press latch A gently until front cover can be
opened.
Closing the enclosure:
Set front cover into flute B and move it to direction
C until latch A snaps in.
Wall mount:
Fix the back cover onto the wall using the screws
in the scope of supply and the D holes. See
packaging for drill pattern.
Ideal height above the floor 1.20...1.50 m (4...5 ft)
it is obligatory to remove the rechargeable batteries from the CO
correctly.
) concentration in the ambient air as the measure for the indoor air
2
Indoor air quality (IAQ)
Very bad
Bad
Acceptable
Average
Good
Very good
+43 7235 605 0 / info@epluse.com
The device beeps decently as soon
as the next lower air quality level
(the next higher CO range) is reached.
2
Tabletop adapter:
Assemble according to sketch
and place the device on it.
.
Guard 10 and use
2
QG_CO2_Guard_10 // v1.0 // Modification rights reserved // 194972