Overheat Protection - Philips HP6522 Bedienungsanleitung

Shave your bikini line as shown in the igure. Move the appliance in
-
different directions.
Shave your underarms as shown in the igure. Move the appliance in
-
different directions.
When you have inished shaving, switch off the appliance and clean
7
the shaving head (see chapter 'Cleaning and maintenance').
Pretrimming with the shaving head and comb before epilation
Use the shaving head and comb to trim the hair in your bikini line to a hair
length of 4mm. You can also use the comb to pretrim long hairs (longer
than 10mm).
Note: Use the comb only under dry conditions to achieve the best results.
1 To attach the shaving head, follow steps 1 and 2 in section 'Shaving
the underarms and bikini line'.
2 Put the comb on the shaving head.
3 Follow steps 3 to 7 in section 'Shaving the underarms and bikini
line'. To obtain an even result, make sure that the comb stays fully in
contact with the skin.
Note: Do not place the appliance on the skin too steeply.

overheat protection

This function helps to prevent overheating of the appliance.
Note: To avoid overheating of the epilator, do not press the appliance too
hard onto your skin. The epilator works best when you move it over your skin
without exerting any pressure.
If the overheat protection is activated, the appliance switches off
automatically and the charging light lashes red for 30 seconds.
You can reset the overheat protection by letting the appliance cool down
and then switch it on again.
Note: If the charging light starts to lash red again, the appliance has not yet
cooled down completely.
EnglisH
11