TECO Professional EasySENSOR Handbuch Seite 4

Remote Controller
Lights on & pair
Adjust Light
Nightmode
Personal
Grouping
On the driver, select which group you want to assign the luminaires by use of the dip switches.
Pairing
Press and hold the pair button, the red light will flash quickly. While holding down the pair button,
connect the luminaire to the powergrid, then release the pair button. The luminaires are now paired.
To unpair do the same with the unpair button.
Choose a group
The settings for choosing a group are matched with the settings on the driver. 1 Stands for A, 2 for B, 3 for C etc.
If you want to adjust a setting for the whole group, select the group on the remote control and adjust the desired
light quantity or color temperature.
Adjust color temperature
Adjust the color temperature from a minimum (2300K) to a maximum (4000K) or do this gradually.
Light quantity
Adjust the amount of light from minimum to maximum or do this gradually.
Preset color temperature
Under this button fixed color temperatures are programmed, 2300K, 2700K, 3000K and 4000K.
Night mode
The night mode button sets the luminaires to the minimum brightness (2300K).
Personal settings
Set own preferences under this button. Set the luminaire to the desired color temperature and brightness and
then keep the button pressed for a few seconds. The setting is then saved.
Ver.EasySENSOR_RC_EN_0919
Lights off & unpair
Adjust color
temperature
Preset color temperature
Choose group
Teconex SA/NV
Rue de Magnée 108 · 4610 BEYNE-HEUSAY · BELGIUM
Tel: +32(0)4/358 85 75 · Fax: +32(0)4/358 23 73 · E-mail: info@teconex.be · www.teconex.eu
EasySENSOR