Power Source - Atari SM144 Handbuch

INTRODUCTION
Your new SM144 is
a
14"
monochrome monilor designed lo display the
video signal lrom your Atari ST or STE computer. To obtain optimum
results, spend a few minutes reading this manual carelully belore you
operate the monitor.
POWER SOURCE
The monitor
is
manufactured
and set to
operate at 9g
to
.lA2
VAC,60
Hz. Plug the AC power cord into
a
standard electrical
ouflet.
Q
Hot",
For inlormation on UK Power Connection, see Appendix
B,
Pouer
Connoclaon ,n
lhe
UK-
Warning: To prevenl lire or shock hazard, do nol expose this
appliance
lo
rain or moisture.
INSTALLATION
Belore using the monitor, lirst install the no-skid rubber leet to the bottom
ol the monilor base. Then connecl the monitor base to the bottom ol the
monilor.
Positioning the Monitor
The base ol the monitor lits against Mega STE compulers to provide
a
secure and convenienl position lor the monitor. ll you are using the
monitor with a Mega STE compuler and you are not going to position the
monilor on lop ol lhe Mega STE, or if you are using the monitor wilh
another computer, make sure lo install the no-skid rubber leet to the
boltom ol the monitor base.