Lehmann electronic VarioRec 6 Kurzanleitung Seite 2

®
VARIOREC
Wireless Emergency Call Technology
Warning
The use of a call device does not release supervisors from the obligation to supervise the persons supported by such a
device.
This system is radio-based and therefore may not be used for monitoring purposes if life-threatening conditions are
foreseeable. This quick reference guide does not release the user from the obligation to read and understand the contents
of the complete
Note: In this quick reference guide the
This quick reference guide describes only the basic functions. It does not cover failures.
Starting the Radio Receiver and Receiving a Radio Call
1
Before a radio receiver can detect a radio transmitter, the latter has to be programmed in the radio receiver.
1
Press and hold the right-hand
button when plugging
5a
...or...
Briefly press
right-hand
button
middle-hand button
transmitter
Nurse call and personal transmiter technologies
Lehmann Electronic GmbH Germany
Quick reference Guide
Variorec6 manual LE399 EN
"VarioRec6 radio receiver" is referred to as "radio receiver" or "receiver".
2
Green
Receiver is
operational
Programming a Radio Transmitter
2
Green
flashing light
Receiver is in
programming mode
6a
5b
1.5 s green
The new radio
transmitter has
Briefly press
been programmed
pull switch
Rehab and care technology
Copyright © 2019
VarioRec 6
3
Trigger
radio call
(transmitters already programmed)
3a
...or...
Trigger
radio call
transmitter
...or...
6b
1,5s orange
The new pull
switch has been
programmed
Phone.: +49 2208 9492 0
LE400 V1.00 page 2 of 4
4
1.5 s red
Receiver indicates and
transmits call
4
3b
1.5 s red
New radio
transmitter
Trigger
has been detected
radio call
pull switch
8
7
Press and
Receiver is
hold
operational again
the left-hand
button
Fax.: +49 2208 9492 32
www.lehmannweb.de
Green