Installation Of The Fireplace - abc home living 25685 Gebrauchsanweisung

Installation of the fireplace

ATTENTION!
1. First, remove all packaging materials such as cardboard, styrofoam, foil, etc..
2. Make sure that the fireplace is off.
3. Your house mains voltage must be at 230V/16A.
4. Plug the power cord into a wall outlet 230V/16A. Route the power cord along the floor.
5. Adjust never quite on a wall, but keep a minimum distance of 10cm, so that ventilation of the
chimney is not obstructed.
6. The fireplace requires no special maintenance.
HANDLING OF ELECTRIC FIREPLACE
A. Controls and Display Symbols
To the left of the control panel there is a switch (I / 0). With this switch, the electric fireplace is activated
or deactivated (I= enabled / 0 = disabled). Function, the following functions only if the I/0-switch is
turned on (I).
There are four keys on the remote control, as well as on the control panel of the fireplace, which have
the same functions.
ON / OFF = ON / OFF switch of the fireplace
DIMMER button = Adjusts the brightness of the simulated flames
LOW key = Turns the heater on a small stage (750 watts). If the heating is already on a low flame, it
turns off.
HIGH = button Turns the heater on high (1500 watts) a. If the heating is already on a high flame, it turns
off.
There are four LEDs on the control panel:
Operation indicator is lit when the fireplace is
working and goes out when it is switched off
again.
Displays the status of the simulated flames.
It lights up when the components are working and
lights up when you change the brightness of the
flame.
Indicates that the heating system operates at
low speed.
Indicates that the heating system operates at a
high level.
The red dot is the infrared receiver for the remote control and must not be covered.
GB2