Cleaning And Storage - BOMANN bs 981 cb Bedienungsanleitung

Blower Aperture
Mains Lead
• To use the device please unwind the entire lead.
• After use you can wind up the lead in the cable duct on the
motor housing.
Parking Position
Operation
General
• Select the desired accessory.
• Unwind the lead completely.
• Insert the mains plug into a correctly installed 230 V, 50 Hz
power socket.
Dry Vacuuming
• Insert the permanent dust bag; it may be necessary before-
hand to remove the hose connection.
• Attach the motor housing.
• Assemble the accessory.
• Turn the device on.
• Vacuum at a steady speed. There is no need to exert
pressure.
Removing and Emptying the Dust Bag
• Turn the device off with the on/off switch (2). Pull the plug
out of the socket.
• Remove the motor housing.
• Take off the hose connection.
• Remove the dust bag.
• Empty the dust bag by pulling off the clip.
• Push the clip back in place and reinsert the bag. Check that
it is inserted properly in the holder.
40
05-BS 981 CB 40
• The device has a blower
function. This enables you to
blow out dust or leaves.
• Attach the hose connection
(8) to the blower aperture
(12).
• On the motor housing your
device has a holder for the
fl oor nozzle.
• Here you can hang up the
nozzle in order to "park" it.
• Reassemble the hose connection and the motor housing.
• Now you can use the device again.
Wet Vacuuming
CAUTION:
• Never use the dust bag when vacuuming up liquids.
Allow the hose connection to discharge directly into the
collection vessel.
• Do not use the fl oor nozzle, but the parquet brush.
• Before the cleaner is used again for dry vacuuming, all
components must be dry.
• Remove the permanent dust bag and reattach the motor
housing.
• Assemble the attachment.
• Switch the device on.
CAUTION:
Turn the device off immediately if foam forms, liquid leaks out
or if the vessel is full.
NOTE:
When the vessel is full the fl oat valve (16) closes the suction
aperture and the motor runs at a higher speed. Switch the
device off immediately and empty it.
Emptying the Collection Vessel
• Turn the device off by the on/off switch (2). Pull the plug out
of the socket.
• Remove the motor housing.
• Empty the collection vessel.
• Reassemble the hose connection and the motor housing.
• You can now use the vacuum cleaner again.

Cleaning and storage

• Pull the plug out of the socket.
• In order not to damage the surfaces, please do not use any
abrasive detergents or scratching cleaning utensils.
Collection Vessel
• Rinse out the collection vessel after use with clean water.
• Any dirt in the vessel can be removed with a sponge or
nylon brush.
Permanent Dust Bag
• Quick cleaning: Tap or brush out the dust bag in order to
remove any residues.
• Hand wash: If soiling is more severe we recommend a
hand wash up to 40°C.
NOTE:
• The bag should only be allowed to dry in the air!
• Only use the vacuum cleaner again when the dust bag is
dry!
26.09.2006, 10:22:44 Uhr