Herunterladen Diese Seite drucken

Audio System GERMAN SOUND X EVO 2 Serie Anleitung Seite 4

Werbung

X-Series
Impedanzlinearisierung
Alle Lautsprecher mit Schwingspule erzeugen zu höheren
Frequenzen eine steigende Impedanz. Erzeugt wird diese durch
einen imaginären Widerstand(Reaktanz). Damit die angepasste
Frequenzweichenschaltung optimal arbeiten kann, wird der
Anstieg durch eine zugeschaltete Impedanz-Linearisierung (R-C
Glied) eingedämmt. Über den Jumper in sektion D lässt sich das
R-C Glied Ein oder Aus schalten. Ob die vorgeschlagene Variante
zum klanglichen Ergebniss führt, muss gemessen oder angehört
werden.
Montage Tips
WARNUNG: Trennen Sie vor der Montage den Masse-Pol (-) von
der Fahrzeugbatterie. Kontrollieren Sie alle Anschlüsse auf richtige
Polung, dies kann sonst zu Kurzschlüssen an der Fahrzeugelektrik
führen. Die besten Einbaupositionen sind die Originalplätze
zwecks Originalität und einfacher Montage. Beachten Sie, dass die
Lautsprecher plan und stabil eingebaut werden. Die Qualität des
Einbaues entscheidet sehr stark das Klangbild, daher sollte auf
Dämmung und Sorgfalt bei der Installation geachtet werden.
Beachten Sie, dass die Lautsprecher vor Hitze,
Sonneneinstrahlung, mechanischen Einflüssen, Feuchtigkeit und
Nässe durch Zubehör von AUDIO SYSTEM geschützt sind.
ACHTUNG: Verlegen Sie Ihre Kabel so, dass diese nicht
gequetscht werden oder über scharfe Kanten verlaufen. Dies kann
zu Kurzschlüssen mit Beschädigungen führen.
Vorsicht: Beim Entfernen von Innenverkleidungen können
Befestigungsteile beschädigt werden, diese müssen Sie ersetzen.
Wichtig: Die richtige Polarität der Lautsprecher zueinander
beeinflusst das Klangbild entscheidend. Dies kann z.B. durch
gemeinsames Verpolen der Hochtöner verbessert werden.
Ausprobieren und hören bzw. messen ist hier sinnvoll!
Optionales Einbauzubehör
- ALUBUTYL 1500, 2000
EVO
und ALU 500
selbstklebende Dämmmatten
EVO
- Dämmung: DOORKIT 1.0 und DOORKIT 2.0
- Z-(T)SC 0.75, 1.5, 2.5, 4.0 Lautsprecherkabel
- MBR165/MBR200 Spritzwasserschutz
audio system germany - falltorstrasse 6 - 76707 hambrückeN
ANLEITUNG / USER MANUAL
(SECTION
D)
SECTION D
, 3000
und 4000, ALU 200
EVO
audio-system
www.
Impedance Linearization
All speakers and voice coils produce higher impedance according
to higher frequencies, created by an imaginary resistance
(reactance). The adjusted crossover circuit works properly, when
the increase through a connected impedance-linearization (R-C
part) is being reduced. With the jumper you can disable or enable
the R-C part. To know if the proposed adjusting is the best sound,
it is important to listen or to measure.
Section D
Resultat
Jumper
Linearisierung
EIngeschaltet
No Jumper
Linearisierung
(Basic)
Ausgeschaltet
Mechanical Installation Tip
Warning: First disconnect negative pole of your car battery.
Check-polarity, changing polarity may cause serious damage to
your car electric. Best speaker positions are the original build in
positions. Easy installation and original look are the reasons.
Please note that the speakers are installed flat and stable. The
quality of the installation decides very much the sound, therefore,
attention should be paid to insulation and care during installation.
Please note that the speakers are protected from heat, sunlight,
mechanical influences, moisture and wetness by accessories from
AUDIO SYSTEM.
Attention: Install all cables as straight as possible without
squashing or laying them over sharp edges. Otherwise this can
cause short circuit or damages to your whole installation.
Attention: Be careful removing original plastic parts of your car.
The fitting parts could be damaged and have to be replaced.
Important: The right polarity of all speakers is extremely important
for the sound of your car audio system. We recommend changing
polarity of the tweeter finding out the best possible sound.
The best is to listen and/or to measure it.
Optional Mounting Accessories
- ALUBUTYL 1500, 2000
EVO
and ALU 500
EVO
- Damping: Doorkit 1.0 and Doorkit 2.0
- Z-(T)SC 0.75, 1.5, 2.5, 4.0 Oxygen-Free Speaker Cable
- MBR165/MBR200 Splash Protection Rings
(SECTION
D)
result
Impedanz-
impedance-
linearization
On
Impedanz-
impedance-
linearization
Off
, 3000
und 4000,ALU 200
EVO
EVO
Self Adhesive Damping Material
.de
EVO

Werbung

loading

Diese Anleitung auch für:

German sound x100 evo 2German sound 130 evo 2German sound 165 evo 2German sound 165-4 evo 2German sound 507 evo 2German sound 609 evo 2 ... Alle anzeigen