Delivery Scope And Transport Inspection; Unpacking; Disposal Of The Packaging; Setup Location Requirements - CASO DESIGN HW 400 Original Bedienungsanleitung

12.2 Delivery scope and transport inspection

As a rule, the Water Dispenser is delivered with the following components:
● Water Dispenser ● Operation Manual ● Water filter
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.

12.3 Unpacking

To unpack the device, proceed as follows:
Remove the device out of the carton and remove the packaging material.

12.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-related
points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste.
Take any packaging materials that are no longer required to "Green Dot" recycling collection
points for disposal.

12.5 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
 The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing
capacity for the HW 400.
 Place the device only on a waterresistent surface.
 Do not use the device outdoors.
 Do not operate the product near hot gas or hot stove.
 Choose the setup location in such a way that children cannot reach the device.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
Please note
25