Herunterladen Diese Seite drucken

Betec S.W.A.T. LOCK-R PRO SN Anleitung

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

The SWAT LOCK-R PRO SN can effectively prevent potential car theft. lt is equipped with four theft deterrent features: warning LED, flashing strobe light,
120 dB ear-piercing siren and hard steel lock. The alarm is built with thick ABS plast ic and has a hard steel frame inside. This immobilizes the car while the
SWAT LOCK-R PRO SN is armed and locked onto the steering wheel. The strobe light flashes along with the siren when triggered, so a theft in progress can
be seen in a dark environment.
A) Check Contents Carefully
1.
SWAT LOCK-R PRO SN unit
2.
One Radio Remote Control unit
3.
Self-adhesive spacers
4.
One warning sticker
5.
Three keys
6.
lnstruction manual
B) Set-up SWAT Lock-R PRO SN on steering wheel
C) Arming/Disarming SWAT LOCK-R PRO SN unit
1.
Locate the power pushbutton on underside of alarm unit, and press once (See Fig. 4). This will activate the power for alarm, but not arm it. This provides
60 seconds to lock alarm unit by turning key counterclockwise, removing key and exiting car.
2.
Point the Radio Control Remote at the front of alarm unit. Press ON-Button once on Radio Remote Control to arm alarm unit. The strebe light should
flash once, and the LED should begin flashing intermittently. lf alarm unit is not armed within 60 seconds of pressing power pushbutton on backside,
then the power of alarm unit will be deactivated. You need to press the power pushbutton again to reactivate the power.
3.
A: If the vehicle is disturbed by window tapping/breakage, door closing or any other significant jolt or bump so first several loud warning tones are
triggered and the strobe light flashes of short duration. B: As soon as A repeats, the siren howls for about 30 seconds with a deafening volume of 120
dB and the strobe light starts to flash. If there is no further disturbance, the device returns to the alarm standby state. Otherwise, the siren and strobe
will triggered for another 30 seconds, until disturbance ends or the alarm unit is deactivated.
4.
To disarm alarm unit, point radio remote control unit at alarm unit and press OFF-button once. The strebe light should flash twice, and LED should
stop flashing. To disarm alarm unit while siren is sounding, press radio remote control OFF-button once to turn off siren and to disarm alarm unit with
two flashes.
5.
Low battery: Beeps once every 5 seconds. lt is time to change both 9V batteries. When the remote LED is dim and the contrel distance is short, it is time
to change Lithium Battery Type CR 2016.
6.
The SWAT LOCK-R is now ready for use.
D) Test the SWAT LOCK-R PRO SN unit
1.
Press the power pushbutton once.
2.
lnstall the SWAT LOCK-R PRO SN unit on the steering wheel.
3.
Get out of the car and arm the alarm by pressing the ON-Button of Radio Remote Control once.
4.
The strebe light flashes once, then the warning LED flashes intermitt ently .
5.
Knocking the windshield/windows and closing the car door will cause the SWAT LOCK R PRO SN to go off for a 30-second siren cycle with strebe light
flashing. lt rearms automatically if no more shock/vibration is detected.
6.
Press OFF-Button on Radio Remote Control once to shut off the siren and to disarm the SWAT LOCK-R PRO SN; the strebe light will flash twice as con-
firmation.
E) Warranty
SWAT LOCK-R PRO SN is guaranteed from defects in materials and workmanship in normal use for a period of one year from date of purchase. Guarantee is
valid as lang as alarm has not been altered or modified or a repair attempted.
CAUTION: S.W.A.T. LOCK - R PRO SN ALARM is effective because it is EXTREMELY LOUD. Prolonged exposure can cause ear damage. Do not acti-
vate alarm unnecessarily. Neither the manufacturer nor the retailer accepts any responsibility for personal injury.
S.W.A.T. LOCK· R PRO SN
INSTRUCTIONS
Requires TWO 9V Alkaline Batteries (Included)
IF YOU NEED ADDITIONAL REMOTES
BETEC BERND EITEL HERZOGSTR. 55
63263 NEU-ISENBURG WWW.BETEC-IDEEN.DE
Additional Remote Sold Separately:
Art. Nr. 8002002
See Your Retailer
Fig. 2
Art. Nr. 8001104
Fig. 3
Fig. 4
Power Pushbutton
Made in China
Fig. 1

Werbung

loading

Inhaltszusammenfassung für Betec S.W.A.T. LOCK-R PRO SN

  • Seite 1 CAUTION: S.W.A.T. LOCK - R PRO SN ALARM is effective because it is EXTREMELY LOUD. Prolonged exposure can cause ear damage. Do not acti- vate alarm unnecessarily. Neither the manufacturer nor the retailer accepts any responsibility for personal injury. BETEC BERND EITEL HERZOGSTR. 55 63263 NEU-ISENBURG WWW.BETEC-IDEEN.DE...
  • Seite 2 ACHTUNG: S.W.A.T. LOCK – R PRO SN ALARM wirkt durch die EXTREME LAUTSTÄRKE. Längere Einwirkung kann zu Gehörschäden führen. Lösen Sie den Alarm nicht mutwillig und unnötig aus. Weder der Hersteller noch Ihr Händler sind für solche Verletzungen haftbar. BETEC BERND EITEL HERZOGSTR. 55 63263 NEU-ISENBURG WWW.BETEC-IDEEN.DE...

Diese Anleitung auch für:

8001104