UNILITE CRI-H200R Anleitung

CRI-H200R
FEATURES
• High quality 200 Lumen COB LED
• Multi-coloured COB LED with high CRI of 96+
SENSOR switch
• 3 Colour temperatures: CCT - 2500k / 4500k / 6500k
• Sensor mode for hands-free operation
• Super tough construction - IK07 shock resistant
• 60° rotational head
• Fully adjustable non-slip silicone headband
• IP65 dust & water resistant
• USB rechargeable - micro-USB cable included
• Red-to-Green charging indicator
OPERATION
Right Switch = COLOUR SELECTION - Warm White 2500k > Daylight 4500k
> Cool White 6500k > OFF
MEMORY FUNCTION:- if left ON in any setting for longer than 8 seconds,
the next press will turn OFF. Next press ON will return to the last colour
setting used.
Left Switch = SENSOR MODE - press left switch to turn SENSOR mode on,
a red light will appear to indicate sensor is activated. Then wave your hand
in front of the light to turn it ON or OFF (sensing distance approx 15cm).
Press SENSOR switch again to turn SENSOR mode OFF.
CHARGING
1. Only use a 5v micro-USB cable.
Red = Red =
2. Switch product off before charging (do not switch on whilst charging).
Chargin Charging
3. Lift the charging port cover on the light.
Green = Green =
4. Plug the micro-USB end of the cable into the socket.
Fully Charged Fully Ch
5. Plug the USB end of the cable into a USB charging plug/port (max 1A).
6. Charge time - 3 hours.
7. Red LED = charging / Green LED = Fully Charged.
**Warranty void if not used with the specified charger**
HEADBAND INSTALLATION
Feed the end buckle through these
ADVICE & IMPORTANT INFORMATION!
holes in the back plate of the
Do not look directly at the LED. Do not operate in direct sunlight or extreme temperature conditions (below -10⁰C or above 40⁰C). The LED will become hot when switched on; do not touch headtorch, then re-attach the
headband back onto the buckle.
and do not place face down on any surface – risk of fire! Do not use the device if there is any visible damage to the housing, plug or cable. Children under 12 years of age should only use the
product under adult supervision.
Do not open, disassemble or attempt to modify the product; this will void the warranty and can be dangerous. Improper use or modification is not covered under the warranty.
Ensure the lens does come into contact with hard/sharp objects; damage to the lens may affect light output.
This product is water resistant to IPX5 – DO NOT SUBMERGE. If the product has been subjected to excessive moisture/water the warranty may be void.
To maintain the rechargeable battery, distributors should recharge the battery every 6 months and users should recharge every 3 months if not using for an extended period. Fully charge
the product before storage. The rechargeable battery will reach optimum performance after several complete charging and discharging cycles.
Protect the battery from heat, intense sunlight, fire, water and moisture – danger of explosion!
If the battery is damaged, fluids can leak out. AVOID contact as this can lead to skin irritation and/or burns. If skin contact happens, rinse thoroughly with water. If irritation persists, seek
medical advice. Also seek immediate medical assistance if battery fluid comes into contact with the eyes.
Do not dispose of this device in normal household waste. It must be disposed of via an authorised disposal centre or at your local waste disposal unit.
Please recycle packaging where possible. Keep these instructions for future reference or for subsequent possessors.
Unilite Limited | The LAB | Moons Moat Drive
T • F •
+44 (0)1527 584 344
ON/OFF switch
Charging Port Charging Port
Detach
headband
from the end
buckle
| Off Winyates Way
E •
+44 (0)1527 584 345 sales@unilite.co.uk
ANSI FL 1 Standard
HIGH
Battery - 3.7v 1500mAh Li-polymer Rechargeable Battery
Dimensions - Headlight - H:48 x W:79 x D:46mm
Weight - 110g
Red = Red =
Charging Chargin
Green = Green =
Fully Ch Fully Charged
Red = Red =
Chargin Charging
Green = Green =
Fully Charged Fully Ch
Red = Red =
Charging Chargin
Green = Green =
Fully Charged Fully Ch
| Redditch | Worcestershire | B98 9FG
W •
www.unilite.co.uk
SENSOR switch ON/OFF switch
200
Lumens
SENSOR switch ON/OFF switch
Charging Port Charging Port
SENSOR switch ON/OFF switch
Charging Port Charging Port
Charging Port Charging Port
Feed the end buckle through these
holes in the back plate of the
headtorch, then re-attach the
headband back onto the buckle.
Feed the end buckle through these
holes in the back plate of the
headtorch, then re-attach the
headband back onto the buckle.
Feed the end buckle through these
holes in the back plate of the
headtorch, then re-attach the
headband back onto the buckle.
| UK
27 M 3 H
Detach
headband
from the end
buckle
Detach
headband
from the end
buckle
Detach
headband
from the end
buckle