cnmemory 66107 Installationsanleitung Seite 2

ENGLISh
Installation manual
Backing up your data
Make a backup copy of your files before installing the new hard disk drive. Please refer
to your computer and / or OS user's manual for more information.
handling percautions
This product is a highly precisioned electro-mechanical device and is very sensitive to
shock and electrostatic discharge (ESD). Please avoid exposure to high temperatures
and humidity. Use the original ESD protection package in which the product was origi-
nally shipped. Please handle the product with care. Damaged or detached label on any
of the components may directly cause product malfunction and will void the warranty.
- Leave the hard disk drive in the static shield package until ready for use.
- Handle multiple the hard disk drives one at a time.
- Do not bump or drop the hard disk drive.
Kit components
- Hard disk drive
- Manual
Installing the hard disk drive of typical computer systems
NOtE!
In some rare cases SATA 1.5 Gb / s hosts can not establish SATA interface connection
with SATA 3.0 Gb / s devices due to interface protocol issues. In this case please
contact the homepage of your manufacturer.
1. This product contains no user-serviceable parts; refer servicing to authorized
personnel only.
2. Do not unpack your hard drive until you are ready to install it. Your hard drive is
packaged in an anti-static bag.
3. Turn off the power of your computer.
4. Unplug the external power cables to the computer.
5. Open the cover of your computer.
6. In order to avoid an electrostatic charge, touch an earthed, metallic object.
7. Handle the hard drive by its sides only. Avoid touching the circuit board componen-
ts on the bottom of the hard drive.
8. Do not drop, shake, or knock down the hard drive.
9. Do not stack the hard drives or stand your hard drive on its edge.
10. Insert the HDD into an available 2.5"/3.5" bay in your computer. Remove as
necessary the existing hard disk drive.
11. Connect cables.
a) Attach the SATA interface cable to the interface connector on the hard disk drive.
b) Attach the power cable to the power receptor on the hard disk drive. The connector
is keyed and will fit in only one way.
c) Check all other cable connections before turning on your computer. Do not force or
rock the connectors into their sockets on the hard disk drive. Push them in straight
until they are seated.
Setting the system BIOS
1. Turn on your computer system. During the startup sequence, run the CMOS (BIOS)
setup program. Newer systems will typically display a message similar to „press
DEL to enter SETUP", showing how to access the CMOS(BIOS) program.
2. Choose a divece position within the BIOS where the hard disk drive will be installed.
3. To make the computer detect the hard disk drive, select the „auto-detect" option then
save and exit the BIOS set up. If your computer supports HDD auto detection, the
hard disk drive will automatically be detected. If you select the type from the Adapter
Primary Master Slave section, „Autotype Fixed Disk: (Press Enter)" will appear on
the screen. If you press Enter, the hard disk drive will automatically be detected.
Partitioning and formatting
The newly installed hard disk drive must be partitioned and formatted before it is ready
for use. If your operating system (OS) is Windows 2000, XP or higher, your OS will
automatically recognize the hard drive. Follow the on screen directions when installing
your OS. Please refer to your OS and / or computer user's manual for more information.
Installing the operating system (OS)
Refer to the operating system users's manual to install the operating system.