Aux Connection; Output Connection; Operation - WHD AMP 100V Bedienungsanleitung

 Priority administration
Mic1 > Mic3, Mic4, Mic5, AUX , NOT Mic2
 AUX connection
The Aux / input sockets are standard stereo RCA Jack phono, single sockets are supplied
and these are linked together internally, this allows stereo signal source to be used without
the need to obtain a special lead, however you may wish to check with the manufacturer of
the signal source to ensure that no damage will result if the left and right output channels
are put in parallel.
 Output connection
Speaker out: Only use one of these outputs at the same time for speaker connection.
Note: If you use the 8 Ohm output, the speaker impedance should not be less than 8 Ohms
AUX out : Use this output to connect additional power amplifiers.
TAPE out : These standard RCA stereo Jack phono sockets provide a mixed output suitable
for connection to a tape or Cassette recorder.

6. Operation

Before switching the power on first time, turn all volume controls to the left position.
After switching the power on , turn the volume controls to the desired levels.
6