Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Usage
•
Connect the IB-1916M-C32 via the delivered cable to the correspon-
ding port of your host computer.
•
When the IB-1916M-C32 has been plugged correctly the LED will turn
on blue!
Application
•
The external SSD can be connected to or disconnected from the
computer without shutting down the computer.
•
Please await the end of read/write operations before disconnecting
the SSD to avoid data loss.
•
A new SSD must first be initialized, partitioned and formatted by the
operation system to be displayed by the system.
•
If the drive isn't recognized instantly by the operating system please
check: if the driver software is installed (USB), if the SSD is initialized,
partitioned and formatted.
Info: Drives must be initialized and have active partitions to be immediately
recognized as volumes in the operating system. If this is not the case, initialize
the drives in the volume management of your operating system.
The full USB 3.2 (Gen 2x2) transfer rate can only be achieved with a
compatible USB 3.2 (Gen 2x2) host computer. Furthermore, the USB 3.2
drivers must be installed by the operating system. If this is not the case, install
the appropriate drivers for your operating system (Windows
Manual IB-1916M-C32
7. Fasten the two screws and
install the delivered acrylic co-
ver. Pay attention to the correct
alignment of the LED window!
®
).
Werbung
