Installation - VINCENT tubeLine DAC-7 Bedienungsanleitung

Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the protective plastic
caps must be removed from all the connections
used at the rear of the unit.
RCA connections
Mechanically identical RCA plugs are available for
analogue and digital outputs. Make sure that you
do not get these connections confused during

installation!

Make sure that you do not mix up the analogue con-
nectors for right and left. The RCA plugs for these are
mostly colour coded as follows:
red for the right channel, black
or white for the left channel.
INSTALLATION
DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
2 1 2 1 2
O U T PU T O U
Contacting the middle pin of the RCA plugs with the
outer ring of the RCA chassis jack may lead to dama-
ges to the main amplifier if it is switched on! To avoid
this hazard, connect or disconnect only in switched-off
B
state and more than one minute after deactivating!
Cable connections
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
- wrong -
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
CD
L
- correct -
Vincent
31