AUDAC LX523B Bedienungs- Und Installationsanleitung Seite 9

Connecting the LX523 to RM523
1 2
3 4
5 6
ok
home
automation
system
When connecting the LX523 speaker system to an RM523 Web based input control unit, both
devices use RJ45 in- and output connectors. In this case, just a regular CAT5 cable (or better)
should be used, on both sides terminated with an RJ45 plug. The connection way of this cable
should be 'Straight', according to the colour standard described before in this user manual.
Connecting multiple LX523 sets to one input unit.
The mains for powering the input units (WP523) is distributed from the LX523 speaker over Pin 3
and Pin 4 (White-Green & Blue conductor) of the twisted pair cabling. When connecting multiple
speaker sets to one single input unit, make sure the mains from only one speaker set is distributed
to the input unit. When connecting all pins (& power supply's) from all loudspeaker sets with each
other, this can cause malfunctioning to the system. To prevent any malfunctioning of the system
the Pin's 3 and 4 from the other speaker sets should be interrupted
LX523 Set 1
.
Attention
Make sure the mains power for the input units is only distributed from one loudspeaker at a
time. When the power is distributed from multiple loudspeaker sets, this can cause
malfunctioning of the system. This can be avoided by interrupting Pin's 3 and 4 of the
twisted pair cabling for the additional loudspeaker sets.
computer
TCP/IP
RS232
UTP cat5
cabling
LX523
LX523 Set 2
Connect
Connect
6 conductors
6 conductors
Do not connect Pin 3&4 Do not connect Pin 3&4
8
stereo
line input
cd player
stereo
line input
mp3 player
stereo
line input
.........
balanced
mic input
stereo
line output
LX523 Set 3
Connect
8 conductors
tunner
WP523