Chauvet DJ Geyser P7 Schnellanleitung Seite 4

EN
Mounting
Before mounting this product, read the
Inverting the Tank
To prevent leaking or spilling, always position the fluid tank with its cap in the uppermost position, above the fog fluid line.
When mounting the Geyser P7 overhead, invert the fluid tank by doing the following:
1. Detach the removable shield by removing the thumb-screw.
2. Pull the fluid tank out and set it on a flat surface.
3. Detach the fluid tank plate by removing 4 screws.
4. Secure the fluid tank plate to the opposite side with the 4 screws.
5. Insert the fluid tank.
6. Secure the removable shield by inserting the end without the thumbscrew into the slot, and screwing in the
thumbscrew.
Mounting Diagram
Fluid Tank Plate
Upwards Fog Output
Omega Bracket (x2)
Surface Mounting
To prevent leaking or spilling, always position the fluid tank with its cap in the uppermost
position, above the fog fluid line.
3
QUICK REFERENCE GUIDE
Safety Notes. Use at least 2 mounting points per product.
Screws (x4)
Mounting Clamp (x2)
Omega Bracket Placement Options
Downwards Fog Output
Safety Cable
Omega Bracket (x2)
Mounting Clamp (x2)
Mounting Clamp (x2)
Omega Bracket (x2)
Safety Cable
Horizontal Fog Output
Geyser P7 QRG Rev. 1