Technical Data; Changing The Blade - Palmera PAC 1010 Bedienungsanleitung

Anleitung PAC 1010 Palmera
9. Servicing and storage
Servicing and cleaning work on the lawn mower and
the removal of the guards may only be carried out
after the motor has been switched off and the plug
disconnected from the power supply.
Worn or damaged blades, blade holders and bolts
must be replaced together by an authorized
specialist to maintain the balance of the mower.
Do not clean the lawn mower with running water,
particularly not if it is at high pressure.
Ensure that all the fastening elements (screws, nuts,
etc.) are tight at all times so that you can work with
the mower in safety.
Check the grass collection device frequently for signs
of wear.
Replace worn or damaged parts.
Store your lawn mower in a dry place. To ensure it
has a long life all the screw parts and the wheels and
axles should be cleaned and then oiled.
Providing your lawn mower with regular care will not
only extend its life and performance but will also help
you to mow your lawn properly and easily.
Clean the lawn mower with a brush or cloth. Do not
use any solvents or water to remove dirt. The
component that is subject to most wear is the blade.
You should therefore check the condition of the
blade and its mounting at regular intervals. If the
blade is worn it must be replaced or ground
immediately. If the mower starts to suffer from
excessive vibrations, this means that the blade has
not been balanced correctly or has suffered
deformation due to impacts. In this case it must be
repaired or replaced.

10. Changing the blade

For safety reasons we recommend that you have the
blade replaced by an authorized specialist.
Important: Wear gloves.
Only use genuine blades, since otherwise the mower
may not function correctly and may even by
dangerous.
Proceed as follows to replace the blade:
Undo the fastening screw using a 24 mm ring
spanner by turning it anti-clockwise.
Remove the blade and replace it with a new one.
When you fit the new blade, be sure to fit it the right
way round. The wings of the blade must project into
the engine compartment (see Figure 11).
Then tighten the fastening screw clockwise. The
tightening torque should be approx. 25 Nm.
At the end of the season carry out a general
17.02.2004 13:58 Uhr
inspection of the lawn mower and remove all the
accumulated residues.
Before the start of each season it is essential that
you check the condition of the blade.
Contact our after-sales department for repair work.
Only use genuine spare parts.

11.Technical data

Mains voltage: 230V
Power consumption:
Motor speed:
Coverage width:
Cutting width:
Cutting heights: 30 - 45 - 60 mm
Grass bag capacity:
Noise level LPA:
Noise level LWA:
Vibration on the strut
Seite 15
GB
50 Hz
1000 W
2800 min -1
34 cm
30 cm
23 liters
79.7 dB(A)
85 dB(A)
10 m/s 2
15