Basic Setup; Switching Off - HH Electronics VECTOR Serie Handbuch

VECTOR SERIES
UNPACKING
Inspect the product during unpacking, if any damage is found, notify the dealer you
purchased it from immediately. Be sure to save the carton and all packaging materials.
Should you ever need to return the unit back to the dealer use only the original factory
packing. Pack all cables neatly, use cable ties to tidy excess cable length in 'figure-8' not
loops.

BASIC SETUP

HH VRE cabs can be mounted on the floor, or a suitable pole or tripod. Don't over-
extend poles/tripods; ensure at least 4 x the pole diameter is still inside the outer
pole. Make sure the legs have a good splay on tripods, but do not obstruct doorways
or other access-ways.
If a pole mount is used, make sure that the thumb screw on the cabinet is tight.

SWITCHING OFF

After using the amplifier, please adjust the gain controls to their lowest settings, then
the amplifier can be turned off safely. Turn the power switch to the OFF position and
remove the power cord from the electrical source.
NOTE:
35mm pole socket
Do not connect or disconnect from the input signal source when the amplifier is
turned ON, damage could occur to the amplifier and the speaker.
(Stand not included)
10
© 2020 HH Electronics Ltd Designed and Engineered in the UK by HH Electronics LTD.