Ordering Replacement Parts; Troubleshooting - Pro Work PS 2000 Bedienungsanleitung

Anl PS 2000 SPK1 17.01.2006

15. Ordering replacement parts

Please quote the following data when ordering repla-
cement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

16. Troubleshooting

Cause
Fault
Automatic oil cut-out has not res-
The engine will not start or dies
ponded
after a short period of time
No fuel
Controller or capacitor defective
Generator has too little or no
Overcurrent circuit-breaker has
voltage
triggered
Air filter dirty
14:12 Uhr Seite 11
Remedy
Check the oil level, top up with
engine oil
Refuel
Contact your dealer
Actuate the circuit-breaker and
reduce the consumers
Clean or replace the filter
GB
11