Achtung: bei Einbau von Betriebsmitteln höherer Spannung als Kleinspannung in die Verteilertür muss sich der Querschnitt der durchgehenden Schutzleiterverbindung nach dem
größten Querschnitt der Zuleitung zu den in der Tür angebrachten Betriebsmitteln richten und in Übereinstimmung mit der Tabelle 3A der DIN EN 60 439-1 / IEC 60 439-1 bemessen
werden.
Attention: in case of assembly of equipment with higher voltage than extra-low voltage into the door of distribution board, the cross section of the continuous protective conductor
connection has to be adapted to the largest cross section of the feed lines for the equipment mounted in the door and rated according to table 3A of DIN EN 60 439-1 / IEC 60 439-1.