axing BVS 10-00 basic-line Betriebsanleitung Seite 4

Field of application:
The devices are suited only for distributing radio and television signals in the
house! If the device is used for other purposes, no warranty is given!
The BVS 10-30 only may be used indoor.
RF Installation:
4
Connect the inline amplifier between the video interconnection point,
the DVB-T antenna and the antenna wall outlet.
4
Use a highly shielded coaxial cable with F connectors (for TVS 10-00
also IEC connectors possible). Suited cables and plugs can be found in
the current AXING catalogue or at www.axing.com.
Power supply:
The inline amplifiers have to be remote feed over the coaxil cable. They are
remote feedable at input 1 or output 2.
Suited power supplys and DC-power couplers can be found in the current
AXING catalogue or at www.axing.com(both are included with the amplifier
set BVS 10-01).
BVS 10-02: This DVB-T amplifier is remote feedable directly by the DVB-T
receiver 3 .
4
Check wether the DVB-T receiver has an integrated power supply,
which can be used, to supply the amplifier. If not, use an external power
supply with DC-power coupler.
4
Active components, such as antennas or amplifiers, which are installed
after the inline amplfier can be remote power fed with the indicated
voltage of the relevant inline amplifier 4.
4
Check wether the power supply can supply all active components.
Check the maximum nominal current of the power supply.
Note: Use a power inserter with integrated DC blocker for remote feeding
the amplifiers. If the amplifier is remote fed at its input, install a aditional DC-
Blocker at its output 1. If it is remote fed at its output, install a aditional DC-
Blocker at its input 2.
The gain of BVS 10-30 can be
adjusted with the attenuator.
Downloaded from www.Manualslib.com
j
k
l
manuals search engine