Preparation And Operation; Filling With Water; Fitting The Wheels - eeese Air Cooler Lea Handbuch

UK
2.

Preparation and operation

Unpack the unit and make sure that the instruction manual, remote control and wheels
are enclosed.
The unit must be placed on a horizontal surface. The unit must not be tilted when it is in
operation.
Check the power supply and ensure that it is in accordance with the parameters of the
air cooler.

Filling with water

If the unit is new or has not been in use in the cooling mode for a long period of time, it
will be necessary to fill it up with clean water before use. The power supply must be
disconnected before filling with water, in order to prevent damage to the electrical parts.
Release the catch on the water container and remove the water tank. Fill the tank with
water up to the maximum – not over, as the water may overflow.

Fitting the wheels

The wheels without brakes must be
fitted at the front and the wheels
Mounting of casters
with brakes must be fitted at the
Assemble the casters without brake on the front and the casters with brake on the back
rear.
front casters
Front wheels
Rear wheels
back casters
Storage
If the unit will not be used for a long
period of time, the water tank must be emptied and cleaned. Allow the device to blow
at the normal temperature for a while, in order to dry the system. In particular, the filter
should be completely dry. We recommend that the unit is kept in its original packaging.
42
i¼o
m
J
MV-2512-01-2020 . eeese-aircare.com © All rights reserved eeese air care ApS
Water level
O p e r a t i n g
i n s t r u c t i o n
1 . T a k e t h e u n i t o f t h e c a r t o n a n d p l a c e i t o n t h e f l o o r .
2 . A s s e mb l e t h e c a s t e r s w i t h o u t b r a k e o n t h e f r o n t a n d t h e c a s t e r s w i t h b r a k e o n t h e b a c k