Velleman-Kit K8057 Bedienungsanleitung Seite 7

4. ' SELECT' (LD3) and 'CONFIRM' (LD4) start flashing.
5. Release 'setup' when leds turn off.
This process takes about 10 seconds.
If the button is released before the leds turn off, the memory will not be cleared.
The unit will now respond to the default code only.
Configuration of CH1 and CH2 :
1. Push 'setup'-button repeatedly to select CH1 (left) or CH2 (right) configuration.
2. Confirm with a long push ('CONFIRM' flashes 3 times (LD4)).
The selected relay will remain ON.
3. Push 'setup' -button a number of times, depending on the desired mode (see table).
At each press, ' SELECT' (LD3) will flash a number of times, indicating the current mode.
The unit returns to normal operation when left idle for 10s.
4. Confirm with a long push (' CONFIRM' flashes 3 times (LD4)).
The selected channel will turn off and the unit is ready for use.
If necessary, repeat sequence for the remaining channel.
flashes
Factory defaults : CH1 : 1htimer, CH2 : 0,5s timer
Instructions
Mode
1 ON/OFF
2 0.5s timer
3 5s timer
4 30s timer
5 1min timer
6 5min timer
7 15min timer
8 30min timer
9 1h timer
7