Troubleshooting - auna multimedia Graceland Bedienungsanleitung

Programming playlists
• While playing back from a music source, press the stop button.
• Press the program button to enter the program mode. The word PROG will flash in the bottom left
corner of the display screen. A position number will also be flashing on the screen (eg: p01).
• Press the next or back buttons to select which track you want to program into position. When you have
made your selection, press the program button to save it.
• You can then repeat the same steps to fill in more positions.
• When done, press play to begin your music playback. You can do this at any stage once you have pro-
grammed the amount of tracks you want.
• At any stage during the program process you can press stop to cancel.
• FUL will display on the LCD screen when the max amount of positions have been filled.
Problem
No radio reception
Disc does not spin, does not play or
sound skips
Programmed playlist does not work
No sound
Noise or humming sound
14
Trouble Shooting
Possible causes and solutions
• The MODE selector has not been set to the correct posi-
tion.
• Adjust the VOLUME knob.
• Rotate the TUNING knob to find a radio station.
• Switch the AUX IN jack to "OFF"
• Did you insert the disc onto the tray with the printed side
facing up?
• Clean the CD.
• Make sure the device stands properly, on a even surface
that is not shaking.
• Make sure the device is connected with the mains power
and fuses are not blown.
• Press STOP. Then press PROGRAM for entering the pro-
gramming mode.
• Turn the VOLUME up.
• Slide the AUX switch to OFF position.
• What is the position of the line out switch? Is any external
amplifier connected but not switched on?
• Move the jukebox away from any other big electronic de-
vices, ac/dc adaptors and especially picture tube tvs or
monitors.