Installation Instructions; Mechanical Installation - Hifionics MEDUSA-Serie Benutzerhandbuch

NOTE
Before you start with the installation of the sound system, disconnect necessarily the GROUND connection wire from the
battery to avoid any risk of electric shocks and short circuits.
Avoid any damages on the components of the vehicle like air bags, cables, board computer, seat belts, gastank or the like.
Ensure that the chosen location provides a sufficient air circulation for the processor. Do not mount the device into small or sealed spaces
without air circulation near by heat dispersing parts or electrical parts of the vehicle.
Do not mount the processor on top of a subwoofer box or any other vibrating parts, whereby parts could loosen inside.
The wires and cables of power supply and the audio signal must be as short as possible to avoid any losses and interferences.
1 4 x
At first you need to find a suitable installation location for
the processor. Ensure that enough space for the installati-
on of the cables remains and that they will not be bended
and have sufficient pull relief.
3 4 x
Marking
Lay the processor aside and then drill the holes for the
mounting screws at the marked locations.
Please ensure not to damage any components of the ve-
hicle while you drilling the holes. Alternatively (depends
on the material of the surface) you can also use self-tap-
ping screws.
18

INSTALLATION INSTRUCTIONS

MECHANICAL INSTALLATION

Drill
2 4 x
Pen or
peening
tool
Keep the processor at the chosen mounting location in
the vehicle. Then mark the four drill holes with an appro-
priate pen or peening tool through the designated moun-
ting holes at the processor.
4 4 x
Mounting
screw
Then uphold the processor to the chosen position and
fix the screws through the mounting holes into the drilled
screwholes.
Ensure that the mounted processor is tightly fixed and
can not come loose while driving.
Mounting hole
Mounting hole