Emos RC218 Bedienungsanleitung Seite 5

Display information changeover
After setting the time and date, you can change the display information by the MODE button
as follows:
Hours + alarm 1 / alarm 2 / dual time / temperature on the right at the bottom.
Setting the temperature unit
Press the Wave °C/°F button to change the temperature units displayed (°C or °F).
Alarm setting
1. Press the MODE button to display ALM1 – alarm #1.
2. Press the MODE button again and hold it; you will enter the regime of setting the alarm #1. Use
(+) (-) buttons to set the required alarm time.
3. Press the MODE button to move in the menu.
4. After setting the time, icon
5. To set alarm #2 (ALM2), repeat the procedure, icon
6. Both alarms can be activated or deactivated by pressing the ALARM ON/OFF button.
Snooze and display backlight (SNOOZE/LIGHT) – contactless
activation
• Press the LIGHT/SNOOZE button when the alarm-clock is ringing to postpone the alarm by 5
minutes, the alarm icon
• Press the ALARM ON/OFF button to switch off the SNOOZE function.
• Press the LIGHT/SNOOZE button to switch on the display backlight. Backlight time is 5 seconds.
• Both functions can also be controlled without any touch upon approaching the hand about
10 cm above the alarm-clock upper side where a movement sensor is located.
• In this case, the button on the alarm-clock back side must be set to ON position. When in OFF
position, the contactless control is switched off.
Setting the second time zone
• Press and hold the (+) button to display the icon
• After pressing and holding the MODE button, you may set the second time by (+) (-) buttons.
• You can only change hours.
Setting the dual time
• Press again the MODE button to display the second time on the right at the bottom – DUAL
TIME.
will appear, alarm 1 is active.
will flash.
and time of the second time zone.
5
will appear.