Petra electric aircurl AC 3 Gebrauchsanweisung Seite 6

AC3_091109_AC3_080509 18.05.10 14:33 Seite 6
•
In case the cord of this appliance is damaged, it
has to be replaced by an authorised service agent
of the manufacturer or a person having similar
qualifications. Substantial dangers for the user
can appear from inappropriate repairs.
Putting into operation
Plug the mains plug into the sockel and switch the unit
on. The aircurl is ready for use immediately.
Use the curler to brush through one strand of hair from
the ends. After a short time in the hot air stream, switch
the unit off and uncurl the hair without pulling it.
When the air outlets are covered or when they are
blocked with hair the outcoming air will be too hot and the
overheating protection switches off the appliance. In this
case switch off the appliance. After about 5 minutes the
cool curl can be put into operation again. If necessary,
clean before the appliance when unplugged.
Cleaning and maintenance
Before cleaning always unplug the appliance.
After using let the appliance cool down and clean it
from hair. Never immerse the appliance in water, clean
it with a damp cloth only and rub dry.
For UK use only
•
This product is supplied with a 13 A plug conforming
to BS 1363 fitted to the mains lead. If the plug is
unsuitable for your socket outlets or needs to be
replaced, please note the following. If the plug is a
non-rewireable one, cut it from the mains lead and
immediately dispose of it. Never insert it into a socket
outlet as there is a very great risk of an electric shock.
•
The replacement of the plug at the mains lead has to
be done according to the following instructions:
Important: The wires in this mains lead are coloured
in accordance with the following code:
blue:
brown:
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
- the wire which is coloured blue must be connected
to the terminal which is marked with the letter N or
coloured black,
- the wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
Do not connect any wire to the terminal which is
marked with the letter E or by the earth symbol
or coloured green or green an yellow.
•
If a 13 A (BS 1363) plug is used it must be fitted with
a 3 A fuse conforming to BS 1382 and be ASTA
approved. If any other type of plut is used, the
appliance must be protected by a 5 A fuse either in
the plug or adapter or at the distribution board. If in
doubt - consult a qualified electrician.
•
Never use the plug without closing the fuse cover.
6
Neutral
Live
,