Werbung
Installation
The electronic LED converter is exclusively designed for the Light Emitting Diode (LED) lamps used in indoors. The electronic converter is a switch mode power supplier with 12VDC constant output
voltage.
An electronic protection circuit switches off the electronic converter in case of short circuit in the secondary circuit, overheat as well as open circuit. This convertor is thermally protected device, the type
of protection is automatic resetting type. After the removing of the faults, the electronic LED converter is ready for operation again.
The unit conforms to the directive 2006/95/EC for the electromagnetic compatibility and the low voltage directive 2014/35/EU.
•
The electronic converter can only be used with the LED lamps.
•
The electronic converter is only suitable for use in indoors. Protect the electronic converter against excessive heat (for permissible operating temperature range see table on page 1).
•
The loads indicated on the converter must neither exceed nor below the following values.
•
Connect the LED lamps to the electronic LED converter with correct polarity according to the schematic drawing.
•
If the electronic LED converter is used for purposes other than originally intended or it is connected in the wrong way, no liability can be taken over for possible damages.
N
220-240V~
L
Elektro Elco AB, Tallvägen 5, SE-56435 Bankeryd, Sweden | info@elco.se | www.hidealite.se | www.hidealite.uk | www.hidealite.fi | www.hidealite.no | www.hidealite.dk
SLT 12V
-
LED LAMP
+
- SLT15 12V Max.15W
- SLT20 12V Max.20W
- SLT30 12V Max.30W
- SLT60 12V Max.60W
Werbung
