Cleaning Instructions; Disposal/Recycle; Troubleshooting - Cuda surgical LLS-3736-2 Bedienungsanleitung

5.

CLEANING INSTRUCTIONS

• Disconnect the Charger from the power source.
Clean the exterior of the charger with a cloth that has been dampened (not dripping) using a
•
hospital disinfectant. Follow applicable hospital protocols during cleaning and dry
immediately.
6.

DISPOSAL/RECYCLE

In accordance with the European Waste from Electrical and Electronic Equipment (WEEE)
•
directive, we encourage our customers to recycle this product whenever possible. Disposal
of this unit must be performed in accordance with the applicable local environmental
regulations.
In the US a list of recyclers in your area can be found at: http:/www.eiae.org/.
•
Please contact our Repair Department to issue a return authorization to return product to
•
manufacturer at the end of product life.
7.

TROUBLESHOOTING

SYMPTOM
Battery not
charging
Charger LED
indicator not
working
LIT-232 ®
CUDA Surgical
Rev. B
POSSIBLE CAUSES/SOLUTIONS
• Ensure charger power cord is plugged in to the AC power outlet.
• Ensure DC connector is plugged into the back of the charger
• Ensure battery is properly seated in the charger bay.
• If repeated attempts to charge the battery have failed, the battery may be
faulty. Replace the battery.
• The charger may have a faulty power cord and/or power brick. Replace the
power cord and/or power brick.
• Ensure charger power cord is plugged in to the AC power outlet.
• Ensure battery is properly seated in the charger bay.
• The charger may have a faulty power cord and/or power brick. Replace the
power cord and/or power brick.
Page 7 of 48
(English)