Wisi TOPLINE OV 75M Betriebsanleitung Seite 25

OV75M A/B= channel
1237MHz=Input frequency A/B
471.00=output frequency,
BER <1.0 e-4= Bit error rate
OV75M
V1.00
Mod No/
Mod init/
REMUX init
OV75M
V1.00
busy
Note:
Encryted programmes are passed
through only via channel A!
Operation
Select the menu item and
adjust the values in a menu line
with the UP/DOWN keys
Enter values and enter and exit
from menu lines with the LEFT/
RIGHT keys
Saving: Data are saved
automatically. Data are retained
in the case of a power failure.
GB
Downloaded from www.Manualslib.com
Channel
Program
!Overfl ow
MUXStat
F-Out*
Out-Att*
OutConf*
QAMRate*
QAMMode*
QAMCarr*
QAMSpec*
Modules*
Mod-No*
.
Version*
.
ModVers
only at
Channel A*
Channel B**
manuals search engine
Settings Remux-QAM
Input channel A/B
Insert here - input module settings
Displays the list of transponder name. Select program

with A * confirms the selected programmes.
Important: Select one programme per channel
If !Overfl is displayed, (total data rate to high)
reduce the program numbers.
Sum of selected programmes channel A/B
Mux on - displaying status of Remux
45-862 MHz, 1 MHz steps
0-10 dB Output level, 1dB steps
loop = Loop through mode
Single = Single output
1.000-7.499 kBaud
?Symbol rate? Incorrect symbole rate
????? refer to note
16, 32, 64, 128, 256 QAM type of modulation
auto/on : auto:QAM signal switches off atom. (see note),
on: signal doesn't switch off automatically.
normal / inverse
Displaying: modules
A:DVBS - module
B:DVBS - module
Remux
Displaying: module number 0-9
Version version of basic unit,
software version module
V 1.00
software version QAM module
1607020
Overflow counter
00...99
Overflow counter shows the account of "overflows".
Counter reset: press simultaneously
Displaying: hard and software version of input modules
A:DVBS - module
S1.0003 - software version
H1.0000 - hardware version
(Key code XX11)
T=tv
R=radio
= encrypted
- 25 -