Lubrication - Heininger xpert Originalbetriebsanleitung

1.5 - 2 mm
Fig. 10
► Work only with sharp clipping blades and replace dull blades and blades with missing
teeth. Proper sharpening of clipping blades is only possible by an expert using
specialised equipment. When faced with the need to sharpen the blades, contact your
service centre.

6.6 Lubrication

Fig. 11
Possible damage to the clipper!
Insufficient oiling of the clipping head will lead to warming and will shorten the life of the
clipper and its blades.
► Oil the clipping blades adequately during the clipping session, at least once every 15
minutes, so that they do not run dry.
► Only use the special oil supplied or a paraffin oil conforming to the ISO VG 15
specification.
Sheep shearing machine Xpert
Downloaded from www.Manualslib.com manuals search engine
Install the new comb plate. Align it so that the
‹
ground surface of the comb plate protrudes
approx. 1.5 - 2 mm above the point of the
upper blade.
Tighten the comb plate screws.
‹
NOTE
To ensure a well-clipped animal and to increase the
life of the device including the shearing head, it is
necessary to apply a thin coat of oil between the
upper blade and comb plate. All other moving parts
of the clipping head must also be lubricated.
Apply some drops of oil onto the clipping blades
‹
and into the lubrication opening.
NOTICE
31