General Information; Tools And Accessories Required - Swim & Fun 1923 Installationsanleitung

UK
1.

General information

1.1.1 Conditions for the installation of a solar collector
The solar collector you have purchased is intended for use with small garden pools, and is easy to
install and handle.
The installation instructions are based on the following conditions:
1. You have a pool which is fully built and filled with water.
2. Your pool has a filter system.
3. You have the required connector hoses to supply the pool and filter system with water
(38 mm Ø).
These are the requirements so that the solar collector can force water through the solar chambers
when it is installed and fully connected to the filter pump.
1.1.2 Use
Once the equipment is installed, it is connected between your filter system and your pool using
the two hose connectors. The connector hose forces the cold water from your filter unit into the
solar chambers of your solar collector. Here it is heated by the sun's energy and then fed on to the
second connector hose towards the pool.
A = feed from the filter unit to the solar collector
B = feed from the solar collector to the swimming pool inlet nozzles
Water heating depends on the following factors: Flow rate and level of sunshine.
Solar heating only functions efficiently in sunshine. It can also remain connected to the pump in
poor weather as this only causes a slight loss of pressure in the pump.

1.1.3 Tools and accessories required

These tools are required for assembly, but are not included in your set:
• Phillips screwdriver
• Flat head screwdriver
1.1.4 The ideal location for your solar collector
Your Solar collector needs to be in a location with as much sunlight as possible.
• Never position the solar collector over the surface of your pool.
• Keep it an adequate distance away from your pool (keep a safe distance).
• The solar collector is designed to allow maximum possible penetration of sunlight.
MV-1923-11-2019 . © Alle rettigheder forbeholdes Swim & Fun Scandinavia ApS
13