Settings; Factory Settings - Magnescale MG10A-P1 Bedienungsanleitung

5. Settings

Th e settings described in this chapter concern the setting of
the parameters for initializing the main unit when the power is
turned on. Th e settings of the parameters which have been set are
retained even aft er the power has been turned off .

5-1. Factory Settings

Stored value settings
Settings are changed using the RS-232C setup command (see
section 5-4).
Item
Reference point
Measuring mode
Preset value
Comparator set number
Comparator upper limit
Comparator lower limit
Start/Hold function
RS-232C trigger input setting
RS-232C output data format
Unit
RS-232C data transfer format
MG10A-P1 / MG10A-P2
Factory setting
Not used
Current value mode
0
1
0 * For all set numbers 1 to 4
0 * For all set numbers 1 to 4
Start function
Low-speed mode setting
+
Measuring mode Go/No
GO judgment result addition
mode (mode 3)
See section 6-1-3.
mm
Separation by spaces
Communication parameter settings
(RS-232C communication setting switch)
Th ese settings are changed using the DIP switches. (See section
5-2)
Communication speed : 9600 bps
Data length : 8 bits
Stop bit length : 1 bit
Parity : None
Delimiter output : " C R " + "
Flow control : Hardware fl ow control (RTS, CTS)
L F "
17
(E)