JBM 53626 Bedienungsanleitung Seite 3

EN
MANUAL OF INSTRUCTIONS
KIT CONTENTS:
• 2 x P800 Sanding Discs
• 2 x P1200 Sanding Discs
• 2 x P2000 Sanding Discs
• 1 x 85gm Polish Paste
• 2 x 3.0ml UV Protect Liquid
FEATURES:
• Designed to restore clarity to headlight lenses that have become yellowed, cloudy, or hazy.
• Headlight lens restoration kit improves the performance of the headlight.
• Three easy steps: sand, polish and protect.
• Easier than replacing an old headlight.
• Comes with easy-to-use instructions.
• Car headlight restoration kit doesn't include household polishing machine.
• Restores headlights, taillights, fog lights or directional lights.
• This kit is intended to restore 2 headlights.
May cause eye / skin irritation.
KEEP OUT OF REACH OF CHILDREN
INSTRUCTION
Prepare: clean the headlight lens with water. Shield the area surroun-
ding the lens to avoid scratches on nearby painted surfaces.
1. Sanding
Wet the sanding disc and attach it to the backer pad. Sand with three
different grits to completely remove the heavy yellowing, fading and
corrosion.
• Use the sanding discs from coarse to fine: P800 > 1200 > 2000
2. Polishing
Attach the wool polish disc to the backer pad and apply the polish
paste. Polish the lens until shine is restored to its original condition.
• For best results, use an electric buffer or polisher. Polishing by
hand: no less than 200 circular strokes clockwise.
3. Protection
Clean the headlight lens and make sure they are dry before conti-
nuing. No sunlight can contact the headlight (key). With the sponge
disc of the kit, evenly apply a layer of the protective liquid on the
surface of the lens. Let the liquid sit and dry (15 min). Then the liquid
should cure in direct sunlight for 1 to 2 hours.
After step nº 3, keep the lens dry and do not allow it to be exposed to
moisture. Do not wash the car for 24 hours.
• Avoid any sunlight when apply the liquid of protection on the head-
light (key).
WARNING!
· 3 ·
• 1 x Masking tape
• 1 x Wool Polish Disc
• 1 x White Sponge Disc
• 1 x Backer Pad M10 Thread
• 2 x Adapter (3/8" & 1/4")