Denon Professional DN-300H Benutzerhandbuch Seite 6

Setup
Important: Connect all cables securely and properly (with stereo cables: left with left, right
with right), and do not bundle them with the power cable.
1. Use a stereo RCA cable or XLR cable to connect the Outputs to the analog inputs of your
external receiver, amp, powered monitors, etc. Make sure the tuner Region is set for your
location (America/Europe/Japan). See
Note: If the unit is powered on, turn its power off and on again after changing this setting.
When the unit powers on again, it will be set for the selected area.
2. Connect the included FM antenna to the FM Antenna Terminal.
3. Connect the included AM antenna
loop to the AM Antenna Terminals.
Make sure the AM loop antenna lead
terminals do not touch metal parts of
the panel. (Even if you use an
external
disconnect the AM loop antenna.)
If you want to hang the AM antenna loop on a wall, use a nail or tack to attach it
(unassembled) to the wall.
If you want to stand the AM antenna loop on a flat surface, assemble it (see images below):
i.
ii.
4. After completing all the connections, use the included power cable to connect the AC In
to a power outlet.
i.
AM Loop
Antenna
6
Downloaded from www.Manualslib.com
AM antenna, do
Put the stand section through the bottom of the loop antenna from the rear and
bend it forward.
Insert the projecting part into the square hole in the stand.
Stand
Square hole
Projecting part
manuals search engine
Operation > Remote Control
not
ii.
for more information.