Manual Defrost; Cleaning, Care & Maintenance; Cleaning The Condenser; Troubleshooting - Scan Cool GN1100BT Bedienungsanleitung

3. Switch on the Power [|]. The current temperature within the appliance is displayed.

Manual Defrost

The appliance will automatically run a defrost cycle every six hours.
Ф Note: The cycle starts from the time the appliance is initially powered up.
To manually defrost the appliance:
1. Press and hold the DEFROST
2. The defrost cycle will start immediately and the Defrost LED illuminates. The defrost will last a maximum of 30 minutes.
Ф Note: Starting a manual defrost also resets the manual defrost timer.
3. The next automatic defrost will start six hours after the manual defrost has finished.
Cleaning, Care & Maintenance

Switch off and disconnect from the power supply before cleaning.

Clean the interior of the appliance as often as possible.

Do not use abrasive cleaning agents. These can leave harmful residues.

Clean the door seal with water only.

Always wipe dry after cleaning.

Do not allow water used in cleaning to run through the drain hole into the evaporation pan.

Take care when cleaning the rear of the appliance. Sharp edges can cut.

An agent or qualified technician must carry out repairs if require.

Cleaning the Condenser

Periodically cleaning the condenser can extend the life of the appliance.
We recommend that your agent or qualified technician clean the condenser

Troubleshooting

If your appliance develops a fault, please check the following table before making a call to your retailer.
Fault Probable Cause
The appliance is not The unit is not switched on
working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
The appliance turns Too much ice on the evaporator
on, but the
Condenser blocked with dust
temperature is too
Doors are not shut properly
high/low
Appliance is located near a heat source or air
flow to the condenser is being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being stored in the
appliance
Appliance is overloaded
The appliance is The appliance is not properly leveled
leaking water
The discharge outlet is blocked
Movement of water to the drain is obstructed Clean the floor of the appliance ( if applicable)
The water container is damaged
The drip tray is overflowing
button for 5 seconds.
2
Action
Check the unit is plugged in correctly and switched on
Call your agent or qualified Technician
Replace the fuse
Check power supply
Call your agent or qualified Technician
Defrost the appliance
Call your agent or qualified Technician
Check doors are shut and seals are not damaged
Move the refrigerator to a more suitable location
Increase ventilation or move appliance to a cooler
position
Remove any excessive hot foodstuffs or blockages to the
fan
Reduce the amount of food stored in the appliance
Adjust the screw feet to level the appliance (if appliance)
Clean the discharge outlet
Call your agent or qualified Technician
Empty the drip tray (if applicable)