mission (presence of other radio appliances
operating on a similar wavelength such as
wireless thermometers, gate controllers etc.).
The broadcast range may decrease rapidly due
to these factors.
9. The home bell (receiver) is designed for
permanent installation indoor or you can use
it as a portable "pager".
Note: If you match another pushbutton (9th and
more), the memory of the first pushbuttons will
be erased automatically in reverse order.
Erasing the memory of paired buttons
• Remove the rear part of the push button cover.
• Set the chime to the pairing mode - depending
from the door chime type, remove the battery
and reinsert or disconnect the chime from the
230 V socket and reconnect.
• Within 25 seconds push the S2 button on the
rear of the push button (transmitter).
• A melody will sound – the memory of all
matched buttons will be erased.
Setting of bell unit
1. The button for choosing of ringing melody is
placed on the front side of the bell unit near
the cover of optical signalization. Choose de-
sired melody by pressing this button – melody
which has just sounded is set.
2. There are two slide switches located on the
lateral side of the bell unit.
• first one is used for setting of ringing volume
(3 levels)
• second switch is used for working mode
setting:
a) only optical signaling (intensive blinking)
b) ringing and optical signaling together
c) only ringing
a)
b)
Pushbutton installation
1. Before you start mounting, make sure that
the doorbell works properly on the place you
have chosen.
2. Remove the back casing of the pushbutton
through the hole in the side of the casing with
a screwdriver.
3. Place this back casing outside your home. Use
double side sticker or screws to fix it on the
Note: The pushbutton unit can be placed on
wooden or brick walls, however, do not place it
on metal surfaces or surfaces containing metal.
It might affect the correct function of the unit.
Problem solving
The chime does not work:
Maintenance
The wireless digital doorbell is a sensitive elec-
tronic device therefore it is necessary to follow
these instructions:
c)
3
wall. Although the pushbutton is waterproof, it
is better to place it under the shelter.
4. Reassemble the pushbutton casing.
5. Press the button, signaling LED on the
pushbutton indicates that radio signal was
transmitted. Bell unit sounds chosen melody.
6. If the signaling LED does not light, battery
is flat, please replace it. Battery usually last
for one year but it may differ according to
conditions.
• It can be out of specified range.
• Amend the distance between both units of
the set. Communication can be influenced
by some interfering objects.
• Flat battery in the pushbutton.
• Replace the battery according to the
polarity indicated.
• Flat batteries in the bell unit
• Replace the batteries according to the
polarity indicated.
• The bell unit should be placed indoor or it can
be used as a portable pager.
• Check the bell and pushbutton frequently and
replace the batteries after a period of time
(use a good quality alkaline batteries).
• Keep the pushbutton away from metal
surfaces such as UPVC doorpost that has a
steel center core.
• If the unit is left unused for a long period of
time, remove the batteries.
• Do not expose both the bell unit and the
pushbutton to excessive shocks.
• Do not expose both the bell unit and the
pushbutton to direct sunlight or moisture.
• Do not use any depurators to clean the
doorbell.
• Do not intervene in the inside of the doorbell.
• Take flat batteries back to the shop where
you bought them or to a collection spot for
their recycling.