Inhaltsverzeichnis
Werbung
GB
Avior
User manual
Thank you for purchasing the planeo Avior.
This document contains the required information for
correct, efficient, and safe use of the product. Consult
the general manual of the 12-volt system
and the user manual of your transformer for more
information about the set up and connection of your
light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.
PRODUCT DESCRIPTION
The planeo Avior is an LED spot for outdoor use. The
fixture can be installed on a fixed underground with
the included screws, or be placed in the ground with
the included spike. This product may only be used
as outdoor lighting in combination with the planeo
12-volt system. Any alterations made to the product
may have consequences for the safety, warranty, and
correct functioning of the product and/or other parts
of the system.
Specifications
Product
Article number
Power (max.)
Luminous flux
Dimensions (H x W x D)
Protection class
Ambient temperature
Cable length
Dimmable
INSTALLATION
Packaging content
[Figure A]
1. Fixture Avior
2. Ground spike
3. Screws
4. Plugs
5. connector
6. Hex key
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us. E-mail: info@
planeo.de
planeo Avior
181S
16W
150 – 1500 lm
125 x 180 x 68 mm
IP44
-20°C to 50°C
1m
Yes, with built-in dimmer
Option 1: placement on a fixed underground or
mounting to a wall [Figure B]
1. Remove the screw from the base using the included
hex key (Figure A [6]).
2. Remove the fixture from the base.
[Figure C]
• Install the base onto the underground with the
included screws.
If necessary, drill a hole in the underground and use
the included plugs.
[Figure D]
1. Place the fixture in the base.
2. Place the screw in the base.
3. Put the fixture in the desired position.
4. Fasten the screw using the included hex key
(Figure A [6]).
Option 2: placement in the ground
[Figure E]
1. Place the spike underneath the base.
2. Properly fasten the spike.
3. Put the fixture in the desired position.
4. Fasten the screw using the included hex key
(Figure A [6]).
5. Place the fixture in the ground.
DIMMER FUNCTION
The fixture is equipped with a built-in dimmer. The
light output can be set to 6 different levels.
[Figure F]
• Push the button to set the desired light output.
6
Werbung
Inhaltsverzeichnis
