Kurgo Tru-Fit Smart harness Anleitungen Und Pflege

ENHANCED STRENGTH
Fitting the harness on your dog
1. Place upper neck straps (F) around pet's head
2. Wrap two lower straps (D) around pet's chest, behind front legs
3. Fasten Nesting Buckles (C) on both sides
4. Adjust all straps to fit comfortably
Warning!
Do not use chest plate D-ring (G) or leash hitch (B) for securing in a vehicle.
Replace harness if it shows signs of wear or has been in a crash situation.
To use as a vehicle seatbelt harness:
Securing your dog safely into the vehicle may be done in two ways.
A) Best Practice - to reduce excursion (pitching forward)
Attach the tether's carabiner through the top layer of the harness's
back strap (A). Next, attach carabiner to buckled vehicle seatbelt,
leaving tether loose.
B) Good Practice
Loop the tether handle around the seatbelt, passing back through
itself. Next, clip the carabiner through the top layer of the harness's
back strap (A). This set up allows for more movement for your dog.
A
Best Practice
To use as a walking harness:
The Kurgo Tru-Fit Smart Harness™ is designed with the owner's and dog's
walking needs in mind. The front chest plate provides a centrally located
D-Ring for leash attachment, which helps deter your dog from pulling.
When your dog pulls, the force redirects them to one side or the other
as you walk together. This sends them back in your direction and reduces
pulling. The easy on-and-off design, and multiple adjustment points
makes the Kurgo harness a great alternative to other training harnesses
and collars.
For training purposes only, do not use with aggressive dogs.
Cleaning Instructions
Our product cleaning instructions will help ensure that your gear has a long, exciting life. Washing by
hand and hang air-drying is the best way to care for your Kurgo products.
Hand Wash Instructions
1. Brush off loose dirt with a dry brush.
2. Spot clean with a damp sponge, cold water, and mild soap. Avoid harsh detergents.
3. If necessary, rinse larger area to eliminate excess soap residue.
4. Hang to air dry (do not machine dry).
NOTICE: Please contact Kurgo directly with any product or warranty inquiries.
Kurgo Products • Salisbury, MA • USA • 877-847-3868 • www.kurgo.com
Instructions and Care
v.3
B
Good Practice
CRASH
TESTED
Crash tested
using this
protocol
Seatbelt
A Back Strap
B Leash Hitch
C Nesting Buckles™
D Lower Chest Straps
F
G
On front,
not shown
in diagram
Fastening the Nesting Buckles:
Seatbelt
Take a piece of the Nesting
Buckle in each hand.
Pull flat and snug the lower straps for a secure fit.
This product
has been
CRASH
TESTED
kurgo.com/product-instructions
E Padded Chest Plate
F Upper Neck Straps
G Chest Plate D-ring
FOR LEASH ONLY
A
C
B
D
E
Pass the smaller piece
through the wide slot of the
larger piece. Kurgo logo
should be pointing up.
All products displaying this symbol
have been crash tested for dogs up to
75lbs at an established university
testing facility. They have been
dynamically or sled tested using the
Federal Motor Vehicle Safety (FMVSS)
213 standards used for child restraint
systems. Results may vary for dogs
weighing more than 75lbs.
Extra-small harness tested
up to 10lbs
Small harness tested
up to 25lbs
Medium harness tested
up to 50lbs
Large harness tested
up to 75lbs
Extra-large harness tested
up to 75lbs
11-17
Seatbelt tether and
carabiner
Final Fit