HAWA Multifold 30 Montageanleitung Seite 10

H A W A
E n g l i s h
Top track and bottom guide channel
1. Screw spacers (1) into the trolleys (2) from the side, see detail A.
2. Slide trolleys (2) and retaining bumpers (3) into the top track (5) in correct order, see page 8.
3. Slide stop bumper (4) into the bottom guide channel.
4. Fit top track and bottom guide channel (5)+(6), see page 13.
How to prepare the panels
5. Recessing for concealed press-fit and guide cups (8)+(9), see pages 6+7, detail A.
6. A mortising template for the recessing and shaping cutter can be made available, see page 6. Guide ring 27 mm (1
cutter with indexable inserts 14 mm (
7. Drillholes for centre hinges (10), see page 7, detail B.
8. Place the pair of panels side by side with their inner face upwards and screw on the centre hinges (10), the small hinge
leaf being on the outer panel, see page 7, detail B.
9. Press in and tighten the concealed hinges (8)+(9) top and bottom. Screw on adapters (11)+(12) top and bottom, see
details A+B. Please note: The top and bottom adapters (11+12) are not identical.
10. Screw the short floor guide unit (13) detail B to the adapter (12). For position, see page 8.
11. For fitting the door catch and lock, see page 9, details N+P.
How to suspend the panels
12. Suspend the outer panel with the concealed hinges. Open the panel about 90°.
13. Place the second panel with the floor guide unit into the bottom guide channel. Connect the first to the second panel with
the hinge pins. Press the adapter eccenter bolts (11) on top into the trolleys (2).
14. Screw in the three fixing screws (14) from the rear, but do not screw them tight.
15. Use the eccenter bolt (11a) to adjust the panel height and tighten the screws (14)
16. Position the bumpers (3)+(4) and screw them tight.
17. If required, fit panel surface equalisers (16) between the individual pairs of panels, see page 9, detail M.
18. Fitting the seal profile. Use the thumb to press the seal profile carefully and evenly into the grooves, see page 5, detail G.
Please note: Stretching the seal profile may cause folds in the rubber to occur.
For combinations with freely sliding panels, see installation instructions 15042.
Multifold 30
9 " ).
16
Technische Änderungen vorbehalten
Sous réserve de modifications techniques
Subject to modification
Hawa AG 8932 Mettmenstetten
Switzerland
Möbelbeschläge
Con riserva di apportare modifiche tecniche
Bajo reserva de modificaciones técnicas
Tel. +41 44 767 91 91 Fax +41 44 767 91 78
www.hawa.ch
1 "),
16
11