Herunterladen Diese Seite drucken

Habitat Nathan Bedienungsanleitung Seite 2

820812 80x170,5x40cm

Werbung

EN
This manual contains important information that should
be kept for future reference.
For domestic use only.
Self-assembly.
Warning! Keep children away from the assembly area.
Leave the plastic bags out their reach. The small parts
pose a choking hazard.
Materials
Structure: powder coated iron.
Box and shelf: medium density fibreboard (MDF) birch
veneer laquered.
Glass top and shelves: tempered glass.
Assembly Instructions
Before starting the assembly, identify all components
using the manual.
In order not to misplace components, do not discard the
packaging until complete assembly is completed.
This product must be mounted by an adult.
Plan to assemble the furniture as close to the installation
location as possible.
Mount on a clean, level surface.
Lay down the glass part gently on a clean, soft surface
free of defects that may scratch or break it.
Tempered glass has the distinction of breaking into small
pieces without danger.
Warning ! Before drilling, make sure there are no pipes
or cables in the drilling hole. Fix the product to the wall
to ensure its stability. Use the type of screws and dowels
adapted to the support.
Over time, fasteners may lose their effectiveness. Check
the tightening of the screws regularly. If necessary
tighten.
Recommendations for use
This product has been designed for indoor use only.
Do not stand on the product.
Do not sit on the product.
Do not overload the shelves.
Do not climb the shelves.
Beware of sharp objects.
Wood-based products, particle board, painted, varnished
and / or lacquered, may give off an odor when opened.
This smell disappears after a few weeks if the room is
properly ventilated.
Nathan - 05/2019
Maintenance
Dust regularly with a dry cloth.
Do not place the product near a heat source (radiator,
chimney, etc.) or a source of moisture. Heat and moisture
can damage the product.
Do not use abrasive products.
Wooden parts
Clean with a soft, damp cloth. Then wipe with a clean,
dry cloth.
Sponge up spilled liquids immediately with a clean, dry,
dabbing cloth to absorb the liquid.
In order not to damage the surface, it is recommended
not to deposit a hot or humid object directly on it.
Do not use magazines or newspapers as a trivet. The ink
used may leave traces that can permanently stain the
surface of the furniture.
To avoid the appearance of marks, do not leave any object
immobile for more than 2 months.
The use of special products for furniture is not recom-
mended or even necessary. Clean the veneer with a soft,
damp cloth. Then wipe with a dry cloth.
Maintain with movements in the direction of the wood
fibers.
Glass parts
Clean with a glass cleaner and a soft cloth, then wipe
with a dry, clean cloth.
Maintain with gentle and circular movements.
Do not put in direct contact with objects that could
scratch the surface.
Do not hit the glass with a hard or sharp object.
Metal parts
Clean with a soft, damp cloth.
To avoid scratches, do not use a recurring sponge or
grain detergent.
Maintain with gentle and circular movements.
Keep the label with lot number, it may be useful
in case of complaint.
If you have any comments or suggestions regarding
this product, assembly instructions or service received,
please enquire at your nearest store or contact us
on our website at: www.habitat.eu or write to this
address: HABITAT, 70 AVENUE VICTOR HUGO, 93300
AUBERVILLIERS FRANCE
1

Werbung

loading