HEAT 3in1 Montageanleitung Seite 2

Important!
Read these instructions carefully before assembling and using the HEAT 3in1.
n The 3in1 should exclusively be used in combination with wood fuel (i.e. firewood).
Always place the firewood on the grate.
n Never use water to extinguish the fire. The fireplace will become rigid and distorted. Always let
the fire die down or use sand to extinguish the fire.
n The product is made of metal. As a result of the construction and the use of thin metal elements,
parts may feel sharp.
n Because of the heat generated during a fire, the metal will discolour like any other heated metal.
Metal is sensitive to minerals and acids that cause rusting. Due to the pollution in the outside air
(and rain) it is normal and unavoidable that your fireplace will rust.
n During the first use smoking parts are not unusual, due to the moisture in the coating.
n During a fire, all parts of the fireplace will become extremely hot. Always make sure that the fire is
out and the fireplace has cooled down before you handle the fireplace, or parts of the fireplace.
n Use of the fireplace by children is forbidden. Keep children under strict supervision during the use
of the fireplace. Use of the fireplace by adults under the influence of alcohol, drugs and/or other
narcotics is strongly discouraged.
n The 3in1 is coated with a heat resistant film. The fireplaces are tested extensively, however, the
coating must first 'cure' or harden. The first fire will cure the coating.
Please take this curing process into account by only making a small fire the first time (only a few
small logs). In this way you will prevent bubbles in the coating, caused by excessively high tempera-
tures.
Assembly instructions
Before use, remove all packaging material from all parts and check that the product is undamaged.
After use, any complaints concerning visible defects cannot be taken into account.
We advise you to assemble the 3in1 at the same place you intend to use for its final location.
Use the drawing on the following page during assembly.